Description
The DAA Universal Magnet Kit is compatible with any of the magazine pouches from Double Alpha Academy (with the exception of the Single Stack Racer Pouch; see separate Magnet Kit).
Includes
- 48mm N52 magnet
- Rubber Washer 22x2mm
- Steel washer 12x0.8mm
- M5x8mm counter sunk screw
- M4x8mm Flat head wide flange screw
- M4x10mm Flat head wide flange screw
Please note that not all parts are required for every type of mag pouch.
Assembly instructions
DAA X-Ray Aluminum Pouches
- Place the rubber washer between the pouch body and the magnet.
- Use the M4 screw to attach the magnet (either 8 or 10mm, whichever fits best)
- You can apply a drop of Loctite. Do not overtighten.
DAA X-Ray Polymer Pouches and Racer Gen-2 Pouches
- Place the steel washer between the pouch body and the magnet. This prevents the insert from pulling out.
- Use the M4 screw to attach the magnet. (either 8 or 10mm, whichever fits best)
- You can apply a drop of Loctite. Do not overtighten.
DAA XiP and DAA Racer Gen-1 Plastic Pouches
(pouches without a pre-drilled magnet mounting hole or thread)
- Drill a centered hole 1.4 cm (0.55”) from the bottom edge using a 6.7–6.9 mm (17/64”) bit. (A 6.5 mm (1/4”) bit can also be used, though the fit will be tighter.)
- Hold the threaded insert inside the pouch, aligned over the drilled hole.
- Place the magnet directly over the hole.
- Thread the M4 screw through the magnet into the insert.
- Tighten carefully—the screw will pull the insert into the plastic until the flange is snug against the inner wall. Do not overtighten. Snug is sufficient.
- Remove the screw, insert the rubber washer between the pouch and the magnet, then retighten. The washer prevents rotation and reduces the chance of the insert pulling out from overtightening.
- You can apply a drop of Loctite. Do not overtighten.
DAA Alpha-XI, and older discontinued DAA Alpha-X and DAA Race Master Aluminum Pouches
- Use the M5x8mm screw to attach the magnet.
- Place the rubber washer between the pouch body and the magnet.
- You can apply a drop of Loctite. Do not overtighten.
Double Alpha Academy

Double Alpha Academy
































