PDR PRO-II Belt Ride Ambidextrous Hanger Kit

The PDR-PRO-II Belt Ride Ambidextrous Hanger Kit includes everything needed to convert your DAA PDR PRO-II holster into an IDPA-compatible holster. This hanger positions the holster close to the body, offers tilt adjustment, and fits 1.5-2” wide belts. It is fully ambidextrous for both right- and left-handed users.

Assembly instructions

1. Remove the PDR PRO-II hanger by unlocking the ball joint screw and sliding it off the rail.
2. Remove the rail and keep the small flat screws safe.
3. Place two washers over each screw nut, then attach the hanger and short screws. Adjust the tilt angle and tighten.
4. For 1.5” belts, use the belt spacers for height adjustment, placing them above, below, or on either side of the belt.
5. To remove a belt spacer, rotate it 90 degrees and slide it out with force.
6. For matches, replace the tension adjustment thumb-screw with the Phillips-head screw included in the kit.

Note: This kit is compatible only with PDR PRO-II holster bodies featuring an aluminum rail with two mounting points, not the older PDR PRO with a plastic T-rail and three mounting points.